Pro-link Oxygen Xlink B14035 User Manual download pdf

PRI MATERIAL SAFETY DATA SHEET N/A=Not Applicable

Prepared by: Regulatory Affairs Dept. (Prepared According to 29 CFR 1910.1200) Effective Date: 1/09 Revision: n/a

SECTION 1-PRODUCT IDENTIFICATION AND SUPPLIER INFORMATION

Manufacturer’s Name:

Misco Products Corporation

Manufacturer’s Address:

1048 Stinson Drive Reading, PA 19605

Manufacturer’s Phone #: (610) 926-4106

Product Name: Prime Time

Generic Name: Waterbased Urethane Wood Finish

Chemical Family: Urethane Dispersion

Formula: Proprietary

Supplier’s Name:

Supplier’s Address:

Supplier’s Phone #:

SECTION 2-INGREDIENT INFORMATION

CHEMICAL NAME CAS NO. WT. % PEL TWA-TLV STEL-TLV

Water 7732-18-5 to 100

Oil Modified Urethane Dispersion N/A 25 to 30

N-Methyl Pyrrolidone 872-50-4 0 to 5 100 ppm 100 ppm

Polyether Modified Dimethylpolysiloxane N/A > 0.1

SECTION 3-PHYSICAL DATA SECTION 4-FIRE AND EXPLOSION HAZARD DATA

Boiling Point (°F): 212 F. Specific Gravity: 1.01

Vapor Pressure: 20mm Hg @ 68 F. Vapor Density (Air=1): >1

% Volatile: 65+ pH: 7.5-8.0

Solubility in Water: Dispersible Evaporation Rate (Water=1): <1

Physical Description: Moderately viscous milky liquid with characteristic odor.

VOC Content (Subpart D §59.406) : 180 g/l

Flash Point (Method Used): N/A

Upper Explosion Limit: N/A Lower Explosion Limit: N/A

Extinguishing Media: N/A

Special Firefighting Procedures: Non Flammable

Unusual Fire and Explosion Hazards: N/A

SECTION 5-REACTIVITY DATA

Stability: Stable Hazardous Polymerization: May occur through oxidation, leading to exothermic

reaction. Heat generated by oxidation may lead to spontaneous combustion of

materials such as rags, paper towels, etc., used for clean-up.

Hazards Decomposition Products: Will not occur. Incompatibility (Materials to Avoid): None

SECTION 6-STORAGE AND HANDLING INFORMATION

Keep out of reach of children. For use by trained personnel only. Keep unauthorized personnel away when applying to floor. Keep container closed during storage. For

institutional and industrial use only. Avoid contact with eyes, skin and clothing. Wear rubber gloves when handling. Wear protective rubber boots when applying to

floor. Avoid breathing of vapors. Use in well-ventilated areas at all times.

SECTION 7-HEALTH HAZARDS AND FIRST AID SECTION 8-SPECIAL PROTECTION INFORMATION

Effects of Overexposure:

Skin: Prolonged or repeated contact may cause dermatitis.

Eyes: Eye irritant. May cause redness or swelling.

Inhalation: Prolonged breathing of vapors may cause dizziness, nausea, and

headaches.

Ingestion: May be irritating to the mouth, throat, and gastrointestinal system.

Vomiting and diarrhea expected with large doses.

Respiratory Protection: Use in well-ventilated area. Organic vapor respirator

when using in poorly ventilated areas.

Ventilation Requirements: Provide local exhaust to keep TLV of Section 2 in-

gredients below acceptable limit. Open doors and windows during use. Continue to

ventilate during drying period.

Protective Gloves: Rubber or chemical resistant gloves should be worn.

Eye Protection: Splash goggles should be worn when handling.

Other Protective Equipment: Eye wash station should be made available nearby.

Chemical resistant footwear (rubber boots) when using product on floor.

First Aid Procedures:

SECTION 9-SPILL OR LEAK PROCEDURES

Skin: Flush with water, then wash with mild soap and water. Seek medical

attention if irritation persists.

Eyes: Flush with large quantities of water, holding eyelids open. Seek medical

attention immediately.

Inhalation: Remove victim to fresh air. Seek medical attention if symptoms persist.

Ingestion: Dilute with 2 glasses of water. Seek medical attention immediately.

Steps to be taken in Case Material is Released or Spilled: Floors will become slippery.

Avoid walking in product. Keep unessential personnel away. Mop up or otherwise absorb

and hold disposal. Avoid discharge to sewer or open waterways.

Waste Disposal Method: Any method in accordance with local, state and federal laws. Best

method is to recycle or reuse for intended purpose. Consult local authorities for disposal in

public sewer. Materials used to absorb product should be soaked in water-filled containers or

rinsed with water prior to discarding in trash receptacles. Do not

dispose of into storm drain,

stream, river or to ground. Rinse container thoroughly before discarding in trash.

SECTION 10-REGULATORY INFORMATION

SARA Title III - Section 311/312 -Hazard Categories: Shipping Information:

HMIS Hazardous Materials

No - Fire Hazard FOR CONTAINERS > 1 Gallon : Floor Wax

Identification System

No - Sudden Release of Pressure Hazard

Health 2

No - Reactivity Hazard FOR 1 GALLON CONTAINERS : Floor Wax

Flammability 0

Yes - Immediate (acute) Health Hazard

Reactivity 0

No - Delayed (chronic) Health Hazard FOR CONTAINERS < 1 GALLON : Floor Wax

Personal Protection B

FOR EMERGENCY MEDICAL OR TRANSPORT INFORMATION: CHEM-TEL, Inc. @ 800-255-3924 (24 hours, 7 days per week)

This product contains the following toxic chemical(s) subject to the reporting requirements of section 313 of the Emergency Planning and Community Right-To-Know Act

of 1986 and of 40 CFR 372.

CAS# Chemical Name Percent by Weight

None

This product contains the following chemical(s) which have been established to be either a carcinogen or suspected carcinogen.

CAS# Chemical Name Percent by Weight

None

SECTION 11-OTHER INFORMATION

This company cannot anticipate all conditions of handling and use of this product. Therefore, this company accepts no responsibility for results obtained by the

application of this information, or the safety and suitability of our products either alone or in combination with other products. It is the responsibility of the user to

provide a safe workplace, using the health and safety information contained herein as a guide. This company will accept no liability for damages or loss incurred from the

improper handling and use of this product.

Pro-Link, Inc.

Canton, MA 02021

1-800-74-LINKS

Oxygen XLink Finish

Summary of Contents

Page 1 - Oxygen XLink Finish

PRI MATERIAL SAFETY DATA SHEET N/A=Not Applicable Prepared by: Regulatory Affairs Dept. (Prepared According to 29 CFR 1910.1

Comments to this Manuals

No comments

Pro-link Oxygen Xlink B14035 User Manual

Browse online or download User Manual for For Home Pro-link Oxygen Xlink B14035. Pro-Link Oxygen Xlink B14035 User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for For Home Pro-link Oxygen Xlink B14035